Ulano Emulsion Selection Guide
QTXPink ColorFor Plastisol
QX-1Blue ColorFor Plastisol and Solvent Based Inks
ORANGEOrange ColorFor Plastisol and some Water Based Inks
TZLight Blue ColorFor Water-based Inks and Plastisol
LX-680Blue ColorFor Plastisol, Water-based Solvent Inks
QLTBlue ColorFor Plastisol and some Solvent Inks
144seconds
162seconds
120seconds
576seconds
360seconds
160seconds
Estimated Base Exposure Timestime is based off 40w standard fluorescent tubes at 4-6" away from screen; coated once on each side of the screen
Ulano QTX Emulsion is presensitized and must be handled in yellow safe light conditions before exposure.NOTE - The product image is intended to show an approximate color of the product when applied to the screen. Actual color may vary. Product listing does not include screen and / or scoop coater.
Photopolymer – These are typically the fastest exposing emulsions, with many exposing correctly from 30-50 seconds. The shortest times can be seen when using a newer LED-type exposure unit.
Dual Cure – If you have established a good exposure time with photopolymer emulsions, you can typically add 90 seconds (1.5 minutes) to that time for most dual cure emulsions.
Diazo - If you have established a good exposure time with photopolymer emulsions, you can typically add 210 seconds (3.5 minutes) to that time for most diazo emulsions.