Discharge printing is a process where water-based inks are applied to certain “dischargeable” dark colored garments to produce very bright, soft prints. As the discharge inks are printed and heat cured, the original dyes in the garment are being reduced, or “discharged,” from the image area. Soft-Hand Discharge inks are an underbase for plastisol inks when printing on dischargeable fabrics. Medium opacity and soft hand plastisols, such as Union’s Ultrasoft (PLUE), Tru-Tone (PRPE), and Unimatch (PTHF) inks, can be printed over Soft-Hand Discharge inks, producing bright, soft-hand prints, even on dark fabrics.
Printers who prefer not to use an underbase can create custom dischargeable colors by using the DSPP-9070 Discharge Base combined with Union’s PIGT-Series Pigments. After the custom color has been created, mix the DSPP-9ZFS agent using the same percentages as described under Mixing Instructions.
White in color
Mesh: Use 156-186 thread per inch (62-73 threads per cm) mesh.
Opacity: Discharge inks are virtually transparent until activated with proper cure times and temperatures.
Stencils: Use any direct emulsion which is listed as water base / discharge resistant on all screens within job. Check with emulsion manufacturer for specifications and proper usage.
Additives: DSPP-9ZFS must be added at specified amounts for the effect to take place. ATEX-9600 Aqueous Stay Open may be added at .5-1% by weight to slow down ink drying into mesh. Small amounts of water may be added to increase inks penetration into fabric.
Mixing Instructions for DSPP-9ZFS Discharge Agent: The discharge system consists of two parts: the ink and the Discharge Agent. The DSPP-9ZFS Discharge Agent is supplied as a powder and sold separately. Add 6-8% DSPP- 9ZFS Discharge Agent of the total weight to the Soft-Hand Clear, Soft-Hand White, or the custom color created utilizing the DSPP-9070 Discharge Base and Union’s PIGT-Series Pigments. Mix until totally dissolved. Minimize waste by only mixing enough of the ink / discharge agent that will be used in a 6-8 hour period.
Printing Instructions: Print the Soft-Hand Discharge inks first, forcing the ink well into the fabric with moderate squeegee pressure. Open mesh / graphic should be flooded immediately after printing to avoid ink drying into screen. If utilizing DSPP- 9050 Soft-Hand Clear, other plastisol or water based colors may be printed without flash curing. The color values of the over-printed inks will appear after curing. You may mist the screen occasionally with water to maintain the ink viscosity during long printing runs. Print custom dischargeable in the same manner.
Curing Instructions: Cure for a minimum of 90 seconds at 320º F (160º C) to activate the discharge reaction and produce a washable print. Evaporating the water too quickly will stop the discharge reaction and result in dull colors.