For mixing accurate and intense colors. For wet-on-wet direct printing on white, light colored fabrics, or underbase whites.
Stencils: Use any direct emulsion or capillary film compatible with plastisol inks.
Additives: Unimatch inks are supplied ready-to-mix. Since plastisol inks "body up" as they sit in the container, you should always stir them well to determine the actual viscosity before adding any reducer. Reducing the ink also reduces the opacity. If you wish to reduce the ink's viscosity, use Viscosity Reducer (PLRE-9000). To extend the ink or to soften the hand further use only Unimatch Soft Hand Extender Base (PTHF-9070).
Color Mixing Instructions: Formulas and instructions for simulating the standard Pantone colors are available from Union Ink on our web page www.unionink.com.
Curing Instructions: Unimatch inks will fully cure and withstand repeated washings when the entire thickness of the ink deposit reaches 300° F (149° C).
Wash-Up: Clean the screens and squeegees with mineral spirits or any Eco-Friendly screen wash designed for plastisol inks.
Caution: Always test this product for curing, adhesion, crocking, opacity, washability, and other specific requirements before using in production.
Application: Screen Printing
Category: Specialty Inks
Sub Category: Base
Best Used By: 12 months
Coverage: Medium Opacity
After Flash Tack: Decreases with increased mesh
Angle: 10° - 20°
Storage Temperature: 65°F - 95°F (18°C - 35°C)