This product requires additional processing timeThe all-new multi-purpose LittleRed X3-D infrared dryer cures direct-to-garment (DTG) printed textiles as well as plastisol, water-based and discharge-printed garments at higher rates than possible with conventional dryer designs.
It features a high-powered pre-heating zone that rockets ink temperatures past 300°F (149ºC) within the first several inches of conveyor travel, maximizing the distance and dwell time for optimum curing of any ink, allowing increased conveyor belt speeds and dryer output.
The Little Red X3-D model is equipped with a 30 in. (76.2 cm) wide conveyor belt and three 24 in. (61 cm) wide infrared heaters (8700W @ 240V total wattage) and can cure 360+ plastisol-printed garments/h, 100+ water-based or discharge-printed garments/h, and up to 50+ garments/h inkjet printed with digital white ink.
With overall conveyor belt length of 88 in. (224 cm) long and 41 in. (104 cm) long heating chamber, the X3-D features a powerful 380 cfm (10.7 cmm) targeted exhaust system as standard to rapidly remove moisture and air contaminates from the heating chamber, as well as cool the skin and controls.
Capacity can be increased as needs grow by adding additional heating chambers, extending the belt length and increasing the infinitely-variable speed setting of the digital belt control.
Can cure plastisol, water-based, discharge and inkjet-printed white ink in record time
[email protected] total wattage
Must be hard-wired into power terminal
Industry-leading 15-year heater warranty
· 360+ garments/hr for plastisol inks
· 100+ garments/hr for water-based or discharge inks
· 51+ garments/hr for DTG digital white ink @ 3 minutes
· 38+ garments/hr for DTG digital white ink @ 4 minutes
Closely spaced coils provide high-density, medium-wavelength infrared heat for maximum cure speed without cold spots or under-curing
Low friction belt aligner and DC belt speed control with digital display
"X-Series" Conveyor Belt Tracking System with Teflon coated fiberglass belt
Digital PID Temperature controller is accurate to +/-1°F
2 - 7 in. (5 - 18 cm) belt-to-heater clearance, adjustable separately on each side for each heater
Add 24 in. (61 cm) chambers and/or 18 in. (46 cm) belt extension